[82% Off] 150-130 Brocade Certified Network Engineer Practice Test Course Coupon

Description

Sample Questions:

Q) What is the default administrative distance for RIP?

A. 1

B. 110

C. 115

D. 120

Q) Which OSPF area is created when the area 51 stub no-summary command is issued?

A. normal area

B. not so stubby area

C. stub area

D. totally stubby area

Q) When is an OSPF virtual link used?

A. When an area has no direct connection to the backbone area.

B. When an area needs access to an ASBR.

C. When an area is configured as a stub area.

D. When an area needs to connect to a non-backbone area.

Q) What is the default implicit behavior at the end of an ACL?

A. log

B. permit any

C. deny any

D. remark

Q) Which two Layer 2 network discovery protocols are used to detect PoE power requirements? (Choose two.)

A. FDP

B. LLDP-MED

C. LACP

D. CDP

Q) What are two Brocade products that are designed for use in a service provider network? (Choose two.)

A. BrocadeFastIronSX

B. Brocade MLXe

C. Brocade Net Iron CER 2000

D. Brocade FCX

Q) You have just configured a new Multi-Chassis Trunk between two Brocade MLXe chassis. Which protocol information will be distributed across this link?

A. IPv6

B. BGP

C. RIPv2

D. STP

Q) Two sites 8 km apart will be connected together using fiber optic cable. Which SFP/cable combination needs to be used?

A. short reach SFP with multi-mode fiber

B. short reach SFP with single-mode fiber

C. long reach SFP with multi-mode fiber

long reach SFP with single-mode fiber